Disc Punch Forceps (Serrated) Straight
This serrated-jaw, straight-configuration disc punch forceps is listed in four catalogue sizes. The product selector associates each 1-4 mm option with its own SKU. Confirm the exact working-end geometry and other dimensions against the offered product specification before procurement.
Working-End Pattern and Selection
Jaw surface
The designation identifies a serrated jaw surface. Verify the tip profile, jaw length and bite dimensions against the current specification.
Orientation
The listed pattern has a straight orientation. Confirm the actual working-end angulation and reach before choosing it for an instrument set.
Size-specific ordering
Use the size selector on this page. The SKU changes with the selected 1, 2, 3 or 4 mm catalogue option.
Available Sizes and SKUs
| Catalogue size | SKU |
|---|---|
| 1 mm | 94876 |
| 2 mm | 94877 |
| 3 mm | 94878 |
| 4 mm | 94879 |
These are catalogue size labels; they do not independently confirm every working-end dimension. The current technical specification should be consulted when exact dimensions matter.
Instrument Application
Disc punch forceps are used in spinal surgical instrument sets where the particular jaw profile and approach are selected by the responsible clinical team. Suitability depends on the actual supplied configuration.
Technical Confirmation
Request item-specific information on the working-end geometry, material grade, finish, overall length, validation and reprocessing instructions. No unsupported sterilization cycle or clinical-performance claim is made here.
Quotation and Procurement
Specify Disc Punch Forceps (Serrated) Straight, the selected size and SKU, quantity, destination and any required drawings or product documentation. The product selector should transfer the selected child SKU into the enquiry.
Frequently Asked Questions
Which catalogue sizes are available?
Four options are listed: 1 mm, 2 mm, 3 mm and 4 mm. Each uses the individual SKU shown above.
Are all working-end dimensions defined by the size label?
No. Confirm the precise working-end dimensions and reach for the offered instrument if they are relevant to your requirement.
How should this configuration be specified?
Include the serrated jaw pattern, straight orientation, selected SKU, quantity and the necessary technical documents.